PIKE ARMS®
PPSh-41 9MM LUGER BARREL
- 10.6" SMG LENGTH - NEW MANUFACTURE
- CHOICE OF FINISHES
   * Unfinished OR Parkerized

PIKE ARMS® PPSh-41 9MM LUGER 10.6" SMG BARREL

CHOICE OF FINISHES:

- Parkerized / Phosphate Finish

- In the White / No Finish

Pike Arms® new manufacture PPSh-41 SMG barrels are chambered in the more popular and inexpensive 9MM NATO (9MM Luger, 9x19) and are a high quality replacement for the increasingly difficult to obtain original barrels and are much more affordable to shoot in 9mm than the original 7.62x25 ammunition.  Each barrel is precision CNC manufactured in the USA by Pike Arms® from new production certified barrel grade steel and available in your choice of either "in the white" with no finish or with a black military parkerized  / phosphate finish for an additional $15.  Please select your preference above when ordering. 

Barrels are completely finished to include chambered and profiled, and are ready for you to install.  The barrel pin slot is started but intentionally left a little bit heavy so that you can easily fit the barrel to your rifle with a file or a dremel for an exact fit.   The barrels are manufactured for standard machine gun trunions to be compatible with machine gun production from most countries.  However PPSh-41 and clones were manufactured by many different countries and manufacturers, depending on your rifle, its possible that some MINOR fitting could be required on the barrel to trunion fit depending on your actual trunion diameter.

It is your responsibility to know and comply with all federal, state and local laws regarding barrel length for your firearm.  The 10.6" SMG length barrels are designed for machine guns, pistols or registered short barrel rifles per NFA regulations and are not intended for semi-auto rifle builds without adding additional length.  You should contact ATF for specific barrel length requirements in the event you have any questions. 

The change from shooting the original and expensive 7.62x25 to this 9MM barrel requires only a simple swapping of the barrel.  The bolts are the same and the magazines are compatible.   Whether you have a gun with the original barrel or you have a kit with no barrel, you can now shoot less expensive and readily available 9mm ammo in your PPSh-41 at a price that will very quickly pay for the barrel in ammo cost savings.

Note however that 9mm ammunition will usually require you to shoot heavier bullets and hotter loads since the original 7.62x25 ammo has considerably more recoil force than 9mm ammunition.  If you are trying to shoot light 115g range ammunition, it will often not consistently cycle with enough force to reliably recoil the heavy bolt and spring.  An easy solution is to either shoot heavier bullets and hotter ammunition or customers have lightened their bolt by removing some metal by either drilling or milling and the lighter bolt then matches the lesser recoil force of 9mm ammunition. 

Review This Product

PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.