STBA AR15 RECEIVER REPLACEMENT RIGHT SIDE BUSHING PER EACH
NOT STBA SET - REQUIRES #06094 INSTALLATION TOOL

STBA AR15 RECEIVER REPLACEMENT RIGHT SIDE BUSHING

- NOT STBA SET

- REQUIRES #06094 INSTALLATION TOOL

STBA Replacement RIGHT BUSHING ONLY for Tactical Innovations' STBA AR15 receiver pin sets. 

If you have a receiver with STBA busings installed and lost one of the RIGHT side bushings,   this replacement bushing will get you fixed up.  This replacement RIGHT side STBA BUSHINGS will only work with STBA pins (available separately) and will not work with GI receivers that have not been drilled and threaded for the STBA bushings. 

Bushings are shipped each.  If you order one, you will get one bushing.  Two bushings are required for each side of the receiver. The left and the right bushings are not identical.  This is a RIGHT SIDE BUSHING ONLY. 

For a complete STBA retrofit kit to include two right bushings, two left bushings and two receiver pins, for a complete retrofit on your receiver, you should use the

Part #: 00172 - STBA KIT

and the

Part #: 00174 - STBA INSTALLATION KIT. 

Review This Product

For installation of the STBA bushings, all you would have to do is accurately drill the existing .154 holes on the same center point using the #1 drill bit.  Its important to make sure that you don't wobble or similar and make the holes oversize.  Then with a hand tap and some tap oil, use the 1/4-40 tap to carefully hand tap the holes. 

 Next you will want to thoroughly clean the holes with acetone or similar to remove all oil and residue.  Then blow dry and apply some red locktite and using the installation tool or allen wrench as appropriate, screw the bushing into the threaded holes being very careful not to cross thread them.  We don't have a torque spec other than tight but not to the point that you damage the threads, the bushing or the tool.

Allow the locktite to set before use.  When you install the hammer and trigger pins, they may be tight in the bushings and that's good.  However, you have to ensure that the pin will allow the hammer to freely rotate.  You can do this by putting the pin through the hammer before you install both in the receiver and make sure the hammer rotates freely.  If the hammer binds on the pin, something has to give and as a fail safe, the right bushing will unscrew from the receiver.  Under normal use with a correctly sized and lubricated hammer, it will work as intended and not be an issue.  The pins are captured in the receiver by the spring identically to a GI lower set. 

PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.