SHARP CLAW EXTRACTOR AND SPRING ASSEMBLY FOR RUGER 10/22 & CHARGER
Precision EDM machined Tool Steel Sharp Claw Extractor for Ruger 10/22, 10/22 Magnum and Charger as well as Ruger Mark II and Mark III .22LR Pistols. This precision extractor is made by Tactical Innovations using wire EDM machining process for the highest quality precision result. The extractor is then processionally heat treated to provide a hard edge that will not wear even under the most demanding of conditions.
The extractor ships complete with a replacement extra-force spring. Both parts are an easy "drop-in" installation with no fitting or gunsmithing required. You can expect positive reliable extraction everytime using a Ruger factory bolt or our PRECISION MACHINED BOLT.
Get greater reliability for a price thats too low not to have one!
Ross Memorial Rifle RangeBlack Hills, WY
The Single Most Important Reliability Upgrade for the 10-22.
When Teaching the Appleseed Program, we saw a ton of 10-22s.
And the most prevalent problem, was failure to extract do to rounded edge
factory extractors, this seemed even worse on the newer Ruger 10-22s.
We suspect that they must have been made from softer steel in recent years.
Please Note: we are talking about Ruger Factory rifles here Not TI or Valquartzen,
or other High end versions.
Nothing is more frustrating for the novice shooter in a class than an endless series
In the past we have used other brands of upgrade extractors that cost more but these seem to be just as good as the others and they work Perfectly.
Very easy to install, we could show a novice how to change there own in minutes!
The second biggest problem was Mags and TI mags are Flawless!!!!!!!!!
Buy with confidence and solve your 2 biggest failure points with a low cost Positive solution!!
That and Clean your Rifle!!! "#. 3" Failure point!
|Was this review helpful?yesno
||20 found it helpful | 1 did not
Kerry DavisPortland, OR
Everything they claimed it would be! The edge is sharp and you can tell its way better to grab the empty than the factory extractor. You have to use your original steel plunger with this new extractor but it only takes a couple minutes to put it in. For $10, I'll be putting this one in all of my 10/22 guns.
|Was this review helpful?yesno
||27 found it helpful | 1 did not
replace the extractor, first remove the bolt from the rifle per the
manufacturer's disassembly instructions. Once you have the bolt on your
workbench, the extractor can easily be replaced by using a punch or a
pick to push the plunger into the bolt and compress the extractor
spring. With the extractor spring compressed, you will be able to
remove the original extractor and replace it with the Sharp Claw
Use caution not to lose the
plunger or spring. When compressed and replacing the extractor, its
easy for your tool to slip off which will then shoot the plunger and
spring across the room.
Once the new Sharp
Claw Extractor is in the bolt with the plunger and spring applying
pressure, manually cam / rock the extractor to ensure that it has full
travel and is not binding. Extractor installation is complete and the
bolt can be re-assembled into the rifle per the rifle manufacturer's