REAR DETENT CAPTURE SCREW FOR TACTICAL INNOVATIONS LOWER RECEIVERS

REAR DETENT CAPTURE SCREW FOR TACTICAL INNOVATIONS T15™ & T15BDX™ LOWER RECEIVERS

This small allen head screw is used to capture the rear takedown spring and detent so you don't have to worry about it shooting across the room when you remove the stock.  Your receiver will hae to be tapped in order to thread this screw in and you may have to clip a couple coils off your detent spring in order to get the correct pressure on the pin. 

The allen head set screw uses a .050 allen wrench for installation and removal.  Its the smallest one in most standard allen wrench sets. 

Overall Rating: 5 out of 5 1 reviews

Review This Product

By Alan Of Oklahoma
I was really impressed with this little kit! If this is the same one that I purchased the kit comes with several little #4X40 set screws and the tap that threads the hole as well as the little allen wrench to install the screws once the rear takedown hole is threaded. I couldn't believe how easy it was to do the install and afterwards you don't have to worry about loosing parts because of the detent spring going flying across the room every time you remove your butt stock. Also this is so simple that a child could do this install with very little challenge. This is definitely worth the price because of everything that comes with it and because of all of the time it saves not having to look for springs and other parts. In fact that is what I am doing now is trying to find this part so that I can buy more of them! THANKS SO MUCH (T-I)
PROP 65 WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.