The Tactical Innovations precision CNC machined PADDLE MAG RELEASE for Ruger® 10/22® rifles and Charger™ pistols gives you a fast and easy mag change for either factory 10 round rotary mags or for any brand of high capacity mags. The paddle mag design is similar to the proven mag release used by H&K for all of their machine guns. Now you can have the same time tested design for your 10/22® rifle or pistol at a fraction of the cost.
The PADDLE MAG RELEASE is machined from billet T6 aircraft aluminum in one piece and is not a welded assembly or a Ruger® factory part with a bolt attached etc. The PADDLE MAG RELEASE quickly and easily installs in your factory trigger assembly (both new plastic ones or original metal trigger housings) with no gunsmithing required and they are available in your choice of colors.
Review This Product Close
Have you purchased this product from us?
Be the first to write a review!
INSTALLATION INSTRUCTIONS
Installation is fast and easy and requires no tools or gunsmithing.
1. Ensure firearm is NOT loaded.
2. Remove barreled action from stock per firearm manufacturer's instuctions.
3. Remove the pin that holds the magazine release in the trigger housing. Hold trigger housing at the same angle after the pin is removed. Do not shake the trigger housing.
4. Remove the factory mag release. Use your finger to keep the magazine plunger from coming out of the trigger housing.
5. Gently press the magazine plunger back into the trigger housing. At the same time insert the Paddle Mag Release into the trigger housing until the pin hole will line up with the pin. The slots on the Paddle Mag Release should face toward the trigger and the flat side of the Paddle Mag release should face the magazine well. Ensure that the auto bolt release is also correctly captured by the same pin.
6. Installation is complete. Test the function of Paddle Mag Release. Place the barreled receiver back in the stock.
