This Endcap TAC DRIVER TOOL is specifically made for the assembly and disassembly of our "Three Lug" end cap suppressors, specifically the STRATUS, QUEST and DIAMOND. This endcap driver tool will not work with "six point" endcaps, such as the TAC52, TAC65 and TAC67. We are often asked why we don't just include the driver tools with the suppressor. The anser is that some people choose to never disassemble and clean their suppressor and rather than include them with each suppressor and have to pass along the additional associated cost with each suppressor, each customer has the option.
This three lug tool drive system is machined from solid 1" hex steel to perfectly fit the complimentary milled lugs in both the front and rear endcaps thus minimizing your chance of damaging the endcap during disassembly. Remember that you'll need two to make the job easier. TAC Driver Tools are "must have" accessories for your .22LR TAC suppressor.
BEFORE you attempt to disassemble your suppressor, be sure to read the Disassembly and Cleaning Instructions for your suppressor at:
- STRATUS Cleaning & Disassembly Instructions
- QUEST Cleaning & Disassembly Instructions
- DIAMOND Cleaning & Disassembly Instructions
Review This Product Close
Have you purchased this product from us?
Be the first to write a review!
